Datalogic Scanning QuickScan QD2100 User Manual download pdf (Page 81)

Wedge Quiet Interval

Product Reference Guide 73

Wedge Quiet Interval

This option specifies the amount of time to look for keyboard activity before the read-

er breaks the keyboard connection in order to transmit data to host. The selectable

range for this feature is from 0 to 990ms in 10ms increments.

Follow these instructions to set this feature:

1. Determine the desired setting in milliseconds.

2. Divide the desired setting by 10 (setting is in 10ms increments). Pad the result with lead-

ing zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 = 20, etc.

3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming

Mode.

4. Scan the barcode: SELECT WEDGE QUIET INTERVAL SETTING.

5. Scan the appropriate two digits from the keypad in Appendix E, Keypad, that represent

the duration which was determined in the steps above. You will hear a two-beep indica-

tion after the last character.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming

Mode.

This completes the procedure to set the Wedge Quiet Interval. See Table 14 for some

examples of how to set this feature.

Table 14. Timeout Setting Examples

NOTE

This feature applies ONLY to the Keyboard Wedge interface.

NOTE

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the beginning.

STEP ACTION EXAMPLES

1 Desired Setting 10ms 150ms 600ms 850ms

Divide by 10 (and pad with leading

zeroes)

01 15 60 85

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT WEDGE QUIET INTERVAL SETTING

Scan Two Characters From

Appendix E, Keypad

‘0’ and ‘1’ ‘1’ and ‘5’ ‘6’ and ‘0’ ‘8’ and ‘5’

6 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 319 320

No comments

Datalogic Scanning QuickScan QD2100 User Manual Page 81