Datalogic Scanning QuickScan QD2100 User Manual download pdf (Page 85)

Intercode Delay

Product Reference Guide 77

Intercode Delay

Specifies the delay between labels transmitted to the host for this interface. The selectable

range for this feature is from 0 to 99 seconds.

Follow these instructions to set this feature:

1. Determine the desired setting.

2. Pad the number with leading zeroes to yield two digits. For example: 0 = 00, 5 = 05, 20 =

20, etc

3. Scan the ENTER/EXIT PROGRAMMING MODE barcode to enter Programming

Mode.

4. Scan the barcode: SELECT INTERCODE DELAY SETTING.

5. Scan the appropriate two digits from the keypad in Appendix E, Keypad, that represent

the duration which was determined in the steps above. You will hear a two-beep indica-

tion after the last character.

6. Scan the ENTER/EXIT PROGRAMMING MODE barcode to exit Programming

Mode.

This completes the procedure. See Table 16 for some examples of how to set this feature.

Table 16. Wedge Intercode Delay Examples

NOTE

If you make a mistake before the last character, scan the CANCEL barcode to

abort and not save the entry string. You can then start again at the beginning.

STEP ACTION EXAMPLES

1 Desired Setting No Delay 5 Seconds 60 Seconds 99 Seconds

2 Pad with leading zero(es) 00 05 60 99

3 Scan ENTER/EXIT PROGRAMMING MODE

4 Scan SELECT INTERCODE DELAY SETTING

Scan Two Characters From

Appendix E, Keypad

‘0’ and ‘0’ ‘0’ and ‘5’ ‘6’ and ‘0’ ‘9’ AND ‘9’

7 Scan ENTER/EXIT PROGRAMMING MODE

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 319 320

No comments

Datalogic Scanning QuickScan QD2100 User Manual Page 85