Datalogic Scanning DS2100N User Manual download pdf (Page 11)

DS2100N QUICK GUIDE

STEP 5 – TEST MODE

Use a code suitable to your application to test the system. Alternatively, you can use the Datalogic Test Chart

(Interleaved 2/5 or Code 39).

1. Enter the Test mode function by holding the X-PRESS™ push button pressed until the TEST LED is on.

2. Release the button to enter the Test mode function.

Once entered, the Bar-Graph on the five LEDs is activated and if the scanner starts reading barcodes the

Bar-Graph shows the Good Read Rate. In case of no read condition, only the STATUS LED is on and blinks.

green

yellow

red

SETUP

LEARN

TEST

READY

GOOD

TRIGGER

COM

STATUS

Figure 8 – X-PRESS™ Interface: Test Mode Function

3. To exit the Test Mode, press the X-PRESS™ push button once.

NOTE

By default, the Test Mode exits automatically after two minutes.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Datalogic Scanning DS2100N User Manual Page 11