Datalogic Scanning DS2100N User Manual download pdf (Page 6)

DS2100N QUICK GUIDE

STEP 3 – X-PRESS™ CONFIGURATION

X-PRESS™ is the intuitive Human Machine Interface designed to improve ease of installation and maintenance.

Status and diagnostic information are clearly presented by means of the five colored LEDs, whereas the single

push button gives immediate access to the following relevant functions:

• Test Mode with bar graph visualization to check static reading

performance

• AutoLearn to self-detect and auto-configure for reading unknown

barcodes (by type and length)

• AutoSetup to self-optimize and auto-configure reading performance in

demanding applications

NOTE

If using the OM2000N accessory, when entering the X-PRESS™ interface, the Oscillating Mirror

remains in the default fixed position (-15°) in order to make barcode reading easier while

performing the X-PRESS™ functions.

The colors and meaning of the five LEDs are illustrated in the following table:

READY (green) This LED indicates the device is ready to operate.

GOOD (green) This LED confirms successful reading.

TRIGGER (yellow) This LED indicates the status of the reading phase.

COM (yellow) This LED indicates active communication on main serial port.

STATUS (red) This LED indicates a NO READ result.

During the reader startup (reset or restart phase), all the LEDs blink for one second.

On the back of the reader near the cable, the “POWER ON” LED indicates the laser scanner is correctly powered.

AUTO LEARN

If you are configuring your scanner using X-PRESS™, you must start with the Auto Learn procedure.

1. Enter the Auto Learn function by holding the X-PRESS™ push button pressed until the LEARN LED is on.

2. Release the button to enter the Auto Learn function.

Once entered, the reader starts a procedure to automatically detect and recognize barcodes (by type and

length), which are presented to it (*). The laser turns on and the LEARN LED blinks to indicate the ongoing

process.

green

yellow

red

SETUP

LEARN

TES

READY

GOOD

TRIGGER

COM

STATUS

Figure 5 – X-PRESS™ Interface: Auto Learn Function

The procedure is as follows:

A) place the desired barcode on the scanline.

B) wait until the LEARN LED stays steady on

(indicating the reader has detected the

barcode).

C) repeat, if needed, the above two steps to

program up to 10 different barcodes (either

by length or by symbology). If more than one

barcode is detected, the Multi Label mode is

enabled (refer to the “2K/4K Family Software

Configuration Parameter Guide” Help file).

* In case of Programming Barcodes, refer to the “ID-NET™ Programming Barcodes And Setup Procedure” document in the

product CD.

1 2 3 4 5 6 7 8 9 10 11 ... 17 18

Comments to this Manuals

No comments

Datalogic Scanning DS2100N User Manual Page 6

Comments to this Manuals

Related products and manuals for Bar code readers Datalogic Scanning DS2100N