Datalogic Scanning DS2100N User Manual download pdf (Page 3)

DS2100N QUICK GUIDE

STEP 1 – CONNECT THE SYSTEM

To connect the system in a Stand Alone configuration, you need the hardware indicated in Figure 1. In this layout

the data is transmitted to the Host on the main serial interface. In Local Echo communication mode, the RS232

auxiliary interface can be used to transmit data independently from the main interface selection. When On-Line

Operating mode is used, the scanner is activated by an External Trigger (photoelectric sensor) when the object

enters its reading zone.

Figure 1 – DS2100N in Stand Alone Layout

CBX100/500 Pinout for DS2100N

The table below gives the pinout of the CBX100/500 terminal block connectors. Use this pinout when the

DS2100N reader is connected by means of the CBX100/500:

CBX100/500 Terminal Block Connectors

Power Outputs

Vdc Power Supply Input Voltage + +V Power Source - Outputs

GND Power Supply Input Voltage - -V Power Reference - Outputs

Earth Protection Earth Ground O1+ Output 1 +

O1- Output 1 -

Inputs

O2+ Output 2 +

+V Power Source – External Trigger O2- Output 2 -

I1A External Trigger A (polarity insensitive)

Auxiliary Interface

I1B External Trigger B (polarity insensitive) TX Auxiliary Interface TX

-V Power Reference – External Trigger RX Auxiliary Interface RX

+V Power Source – Inputs SGND Auxiliary Interface Reference

I2A Input 2 A (polarity insensitive)

ID-NET™

I2B Input 2 B (polarity insensitive) REF Network Reference

-V Power Reference – Inputs ID+ ID-NET™ network +

Shield

ID- ID-NET™ network -

Shield Network Cable Shield

Main Interface

RS232 RS485 Full-Duplex RS485 Half-Duplex

TX TX+ RTX+

RTS TX- RTX-

*RX+

CTS

*RX-

SGND SGND SGND

* Do not leave floating, see Reference Manual for connection details.

CAUTION

Do not connect GND, SGND and REF to different (external) ground references. GND, SGND

and REF are internally connected through filtering circuitry which can be permanently

damaged if subjected to voltage drops over 0.8 Vdc.

DS2100N

Host

PG 6000

P.S.*

* Presence Sensor

(for On-Line mode)

MAIN

I/O, AUX

CBX100/500

1 2 3 4 5 6 7 8 ... 17 18

Comments to this Manuals

No comments

Datalogic Scanning DS2100N User Manual Page 3

Comments to this Manuals

Related products and manuals for Bar code readers Datalogic Scanning DS2100N